Installation

The Ultimate Switch™ skydive blow switch consists of 3 units (parts):

• 1 Camera plug with wire and terminals

• 1 Ultra Light Pressure Switch

• 1 Black silicone tube/hose 60cm length

With these individual parts, you have a very easy installation and a nice and discreet look on your helmet
setup. The Ultimate Switch™ placement; you can use a double-coated foam tape that adheres and shapes
to a wide variety of surfaces. (example: 3M Scotch® Mounting Tape).

The Ultimate Switch™ may remain installed inside the helmet at all times.

The plug & wire part can be installed anywhere. You don’t need to drill a big hole on your helmet like other
installation kits require. Hole size: a 6/7mm hole is enough to route the cable/terminals into the helmet.

The hose/tube is the easiest part to install :)